Assembly Operator

  • Continental
  • 610 Reeves Ave, Albemarle, NC 28001
  • Full-Time



Check out similar listings!

Loading some great jobs for you...




Job Description

Overview:
Assemble foundation products for the Henderson facility in a safe and efficient manner, to satisfy the customer demand for a quality product. Participate in Cross Functional Teams, striving for continuous improvement through waste elimination, and other tasks as assigned by the supervisor.

Core Responsibilities:
Production:
Become an active member of the production team, contributing ideas, supporting harmonious work relationships, and efficient work habits.
Assemble, test, and pack foundation brake components at specified rates.
Assist in troubleshooting process problems.
Ensure that the production facility is clean and orderly.
Inspect and rework parts as required.
Assist in the changeover of the equipment for various products.
Observe all company policies and procedures.
Quality:
Monitor consistency of the product and the process to protect our customer.
Follow established work procedures.
Perform necessary quality checks (first piece part, SPC, masters, etc.)
Complete all quality required documentation (SPC Charts, safe launch tally, superforms, etc.)
Actively participate in Quality training, containments or support work.
Continuous Improvement:
Actively support the identification and elimination of waste with the objective of achieving a process that flows the product at the pull rate of the customer.
Submit continuous improvement suggestions.


Safety:
Observe all safety regulations including use of personal protection equipment (safety glasses, steel toe shoes, gloves, etc.).
Report all unsafe conditions or events to Group Leader, Area Manager, or EHS representative in a timely manner.
Compliance to all Continental and Henderson plant permits, policies and procedures including, but not limited to, environmental, health, safety, security, ISO 14001 and Environmental Management systems, TS 16949 and Quality Management Systems, Human Resources policies, and Continental Business System elements.
Other:
Participate in steering Committees or other special assignments on a voluntary basis
**Physical and Mental Demands:
Physical: Moderate to Substantial. Constant standing, walking and repetitive hand/finger work. Lifting/carrying or pushing/pulling piece parts from .5 ounce up to 50 lb. totes on regular basis. Occasional bending, stooping reaching above shoulder height or below knees required. Position normally cannot be performed by alternating sitting or standing. May work with oils, lubricants or solvents, metal dust or shavings. Good visual acuity and manual dexterity required.
Mental: Minimal to Moderate. Procedures are well established and communicated; consistent focus to process and quality is important.

Job Requirements

Basic Requirements:
High School Diploma or GED
Bennett Mechanical Aptitude Assessment
Basic Math computation skills
Ability to read, understand, and apply operator instructions and complete necessary Production documentation or reports.
Team building, positive interpersonal skills and effective communication skills are needed.
Must be able to perform in and adapt to a mass production environment and flexible to various work assignments or changes a needed to fit the needs of the business
Ability to work overtime as needed to meet production schedules
Preferred Requirements:
1 2 years of industrial manufacturing experience

Job Type

Manufacturing

Job Category

Manufacturing Operations and Production--Operations


Associated topics: assemble, assembler, assembly, installation, reassemble, re assemble


* The salary listed in the header is an estimate based on salary data for similar jobs in the same area. Salary or compensation data found in the job description is accurate.